Series 7 is a silicone protective film for die-cutting and shipping
Type | Base film thickness（μm） | SUS 304 Adhesion（g/inch）-20min |
7201C | 50 | 0.5 |
720C | 50 | 2.0 |
721C | 50 | 3.0 |
722C | 50 | 5.0 |
723C | 50 | 8.0 |
724C | 50 | 13.0 |
725C | 50 | 18.0 |
Type | Base film thickness（μm） | SUS 304 Adhesion（g/inch）-20min |
7301C | 75 | 0.5 |
730C | 75 | 2.0 |
731C | 75 | 3.0 |
732C | 75 | 5.0 |
733C | 75 | 8.0 |
734C | 75 | 13.0 |
735C | 75 | 18.0 |
【Product Features】
1. Exhaust 2.Easy to separate 3.No residual glue
【 Points for attention】
Avoid collision during transporting and storing, and never directly rolling the product in the ground, and must be dangling in storage;
Avoid squeezing the surface of the product from points or surfaces, which can lead to apparent abnormalities
Avoid long-term exposure in air (more than 30min), as long-term exposure may cause the peeling strength to become higher and need to remove the exposure part.
Avoid long-term placement of the product in a high temperature and high humidity (≥50 °C * 80%RH) environment, which may cause in organic silicon layer and color layer falling off.
Avoid wiping the surface of the product with chemical solvents (such as alcohol, toluene, etc.), which may cause the layer to fall off;
The product may generate static electricity during processing, and it is necessary to eliminate static electricity in time to prevent the apparent or performance abnormalities caused by static electricity
The product will have a certain transfer when contacting the roller, and the roller needs to be cleaned regularly to prevent different products from polluting each other;
Avoid surface scratches and too deep knife marks, which may lead to tape penetration and abnormalities.
Document：None